All projects containing a FPGA or CLPD are posted in this section

7 Segment Displays

By xantus on vrijdag 5 maart 2010 04:25 - Comments are closed
Category: Verilog examples, Views: 11.996

An easy way to add debug capabilities to your project is by using the 7-segment displays. The following piece of verilog code shows you how to control the 4 multiplexed common-cathode displays. The digitx inputs are BCD. The fifth bit (digitx[4]) is for blanking the digit (1=off, 0=on).

Read more »

VGA timing

By xantus on donderdag 4 maart 2010 07:43 - Comments (1)
Category: Verilog examples, Views: 9.727

Figure 1 illustrates the basic timing requirements for each row (horizontal) that is displayed on a VGA monitor. An active-low pulse of specific duration (time a in the figure) is applied to the horizontal synchronization (hsync) input of the monitor, which signifies the end of one row of data and the start of the next. The data (RGB) input on the monitor must be driven low for a time period called the back porch (b) after the hsync pulse occurs, which is followed by the display interval (c).

Read more »

Rotary Encoder

By xantus on maandag 1 maart 2010 20:24 - Comments are closed
Category: Verilog examples, Views: 6.378

The following code is for a rotary encoder with 2-bit gray code output. It has an 8-bit output which increases/decreases by rotating the rotary encoder

Read more »

PS/2 Keyboard Communication

By xantus on donderdag 18 februari 2010 13:41 - Comments (1)
Category: Verilog examples, Views: 16.504

PS/2 keyboard communication is actually a very simply protocol too implement on a FPGA. The clock is provided by the keyboard and the data is sent in 11-bit frames. The frame-bits are:
  • 1 start bit; always 0
  • 8 data bits (LSB first)
  • 1 parity bit (odd parity)
  • 1 stop bit; always 1

Read more »

USB Communication (RS232)

By xantus on woensdag 17 februari 2010 08:01 - Comments (4)
Category: Verilog examples, Views: 5.862

The USB 2.0 capabilities are provided by the FT232RL, which is an USB to UART converter IC. So we just have to write some verilog to create an UART module to interface with the FT232RL for USB communication :) .
The verilog consists of 3 modules: baud_generator, uartrx and uarttx.

Read more »